Drill hole to the correct diameter and depth, clean the hole using a brush and compressed air in the following sequence: 2 × blow, 2 × brush, 2 × blow, 2 × brush, 2 × blow. Once the holes are prepared, remove the screw cap from the cartridge. Attach mixer nozzle was provided with the cartridge. Place the cartridge in the applicator gun. Dispense approx. 10 ml of resin to waste until an even colour is achieved. Inject resin into the far end of the hole and fill approx. 2/3 full. Insert a threaded bar with a rotating motion to the bottom of the hole and leave it undisturbed until load time has elapsed.
In order to provide a more relevant experience for you, we use cookies to enable some website functionality. Some of the cookies are used for statistical purposes while others are set up by third party services.
By clicking "Allow", you accept the use of all the cookies on the platform. Click "Decline Non Essential" to select only strictly necessary, or "Preferences" to make more detailed choices.