PLA Plus+ is a good choice for a printing material if you are looking for high accuracy and high resolution. It does not require a heated base and has a very low shrinkage rate (0.3%). PLA Plus+ is stronger than ordinary PLA, possessing the same strength as normal ABS material.
This 1.0kg spool features a thickness of 1.75mm ±0.10mm, with a roundness variation of only 0.03mm. It has a nominal processing temperature range of 205 ~ 225°C (401 ~ 437°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament. The negatives of using PLA Plus+ is that it is vulnerable to degradation from moisture, sunlight, and heat. Additionally, it is more prone to overheating during processing, which can cause dripping and drooping if it gets too hot.
Specifications | |
Available Colors | Black, Bondi Blue, Cadet Grey, Café Noir, Cornsilk, Gold, Green, Grey, Lime Green, Orange, French Plum, Red, Royal Pink, Wageningen Green, White, Yellow |
Filament Type | Monoprice PLA+ |
Print Temperature | 205-225 °C |
Bed Temperature | No Heat 60-80°C |
Density | 1.24 g/cm3 |
Distortion Temperature | 0.45°C |
Tensile Strength | 60 Mpa |
Bending Strength | 87MPa |
Flexural Modulus | 3642MPa |
IZOD Impact Strength | 7kJ/m2 |
In order to provide a more relevant experience for you, we use cookies to enable some website functionality. Some of the cookies are used for statistical purposes while others are set up by third party services.
By clicking "Allow", you accept the use of all the cookies on the platform. Click "Decline Non Essential" to select only strictly necessary, or "Preferences" to make more detailed choices.