- The unit has an Ethernet interface.
- Has a square connector with three slits for the mains.
- Engineered for superior durability.
With the novaNet connection from the moduNet292 to an automation station (AS), the maximum extended novaNet network time constant must not exceed 120 µs. This means that a segment of a novaNet cable may have a maximum time constant of 30 µs (max. 300 Ω / 200 nF).
When using a moduNet292, a resistance of 1000 Ω (¼ W, 10%) should also be implemented, if it is not already there, at a position in the novaNet between a and b This is done to reduce the interference effects of incorrectly installed novaNet communication subscribers (e.g. lack of connection to the protective earth) or interference-sensitive wiring.
The Ethernet connection of the moduNet292 is a 10Base-T connection and can be used with standard Ethernet cables, preferably CAT-5.
10Base-T (IEEE 802.3i) runs via four wires (two twisted pairs) of a CAT-3 or CAT-5 cable. A hub or switch is located in the middle and has a port for each subscriber. The transmission speed is 10MBit/s and the maximum length of a segment is 100 m.
| Specifications | |
| Model | EY-BU292F002 |
| Power | 230 VAC |
| Ethernet | 1 × RJ-45 socket, 10 Mbit/s (10 Base-T) |
| RS-232 serial port | 1 × DB-9 (male) as per DTE (57k6, 8n1) |
| TCP/IP address | 192.168.10.20 |
| Subnet mask | 255.255.255.0 |
This website uses cookies.
In order to provide a more relevant experience for you, we use cookies to enable some website functionality. Some of the cookies are used for statistical purposes while others are set up by third party services.
By clicking "Allow", you accept the use of all the cookies on the platform. Click "Decline Non Essential" to select only strictly necessary, or "Preferences" to make more detailed choices.